597308

Special Features: Skf axial clamp seals are produced in three different DESIGNS:CT1, CT3, and CT4 design; these axial clamp seals are made of appropriately profiled strips of non-reinforced nitrile rubber which are held firmly in place by stainless steel screw-type clamps; they are available in the diameter range 150 to 4600 mm; the seals do not rotate but seal axially against a rotating counterface; CT3 design:the seals of the CT3 design differ from those of the CT1 design only in the form of the sealing lip; this is again flat but is provided with annular grooves; these serve to trap contaminants which may have started to penetrate the lip/counterface contact; the maximum operating interference for these seals is +4, 8 mm; SHAFT:42.500 in.; OD:43.688 in.; WEIGHT:4.250 lbs III Part Name Assigned By Controlling Agency: Axial clamp seals CT3 design Seal Width: 1.125 inches nominal

Special Features: Skf axial clamp seals are produced in three different DESIGNS:CT1, CT3, and CT4 design; these axial clamp seals are made of appropriately profiled strips of non-reinforced nitrile rubber which are held firmly in place by stainless steel screw-type clamps; they are available in the diameter range 150 to 4600 mm; the seals do not rotate but seal axially against a rotating counterface; CT3 design:the seals of the CT3 design differ from those of the CT1 design only in the form of the sealing lip; this is again flat but is provided with annular grooves; these serve to trap contaminants which may have started to penetrate the lip/counterface contact; the maximum operating interference for these seals is +4, 8 mm; SHAFT:42.500 in.; OD:43.688 in.; WEIGHT:4.250 lbs III Part Name Assigned By Controlling Agency: Axial clamp seals CT3 design Seal Width: 1.125 inches nominal ASAP can help source this line with documentation review, alternate part checks, condition requirements, and account manager follow-up for urgent or planned procurement.